Greetings everyone
Happy Monday, everyone in this amazing community; how are you all doing today? I hope you all are doing well and you had a peaceful weekend. Today, I am very excited to share a post here with you guys, which is all about making a beautiful bracelet for my mum to use to beautify her Sunday outfit.
This was a gift from me to her, and she was feeling happy to receive it because it looked cute on her.
I calculate my head before coming up with this design. I was doing try and error until I was able to come up with this.
This design was created by me, and it will be good to share with you guys some simple steps I followed to achieve it.
Here are the outcomes of the bracelet.
Material used
- Pearl beads
- white beads
- fishing line
- bracelet hug
- needle etc
To proceed, I cut out the length of the fishing line that will reach the bracelet I am going to make.
I then pick 7 white beads and pass them through the fishing line with the help of a needle.
After that, I then go through the 7 white beads again.
I then tight it at this point and then cut out the tail
I then pass forward the fishing line with two white beads. I then pick 3 white beads, 1 pearl bead, and again 3 white beads.
I then go through the previous white bead and then pass it upward by the next 3 white beads, here is the outcome of it.
I then pass the fishing through the pearl bead to the opposite side. I then pick 7 white beads.
Then go through the previous bead which is the pearl bead. See the photo below.
I then pass upward through the entire 7 white beads to reach the starting point.
I then pick two white beads and pass through the fishing line.
I then pass the fishing line around the 7 white beads. See photo below
I then pick another 2 white beads from this point. Then, pass the fishing line upward by 4 white beads, which is the center. Which i achieve the first step
I then pick 3 white beads, 1 Pearl, and 3 white beads through the fishing line.
I then go through the previous white bead, then upward through the next 3 white beads. See the photo below.
I then pick 7 white beads again.
I then go through the previous bead; see the photo below.
I then go through the 7 white beads again, then pick 2 white beads.
I then go through downward.
I then pick another two white beads and then pass the fishing line upward by 4 white beads to be at the center. Here is the outcome of it.
I then continue with the same process to achieve the next four steps.
After making some calculations, I discovered I needed about 7 steps to complete the length needed.
Reaching I pass 7 white beads.
I then go through the previous white bead and then tighten it and cut out the excess.
I then attack the bracelet hug at both ends and here is the finished work.
I hope this looks beautiful. Thank everyone for your time
Posted Using InLeo Alpha
